[Braindump2go] 350-080 Study Guide Free Get (281-290)

CISCIO NEW UPDATED: New Updated 350-080 Exam Questions from Braindump2go 350-080 PDF Dumps and 350-080 VCE Dumps! Welcome to Download the Newest Braindump2go 350-080 VCE&PDF Dumps: http://www.braindump2go.com/350-080.html (394 Q&As)

Important News: Cisco 350-080 Exam Questions are been updated recently! The Cisco 350-080 Practice Exam is a very hard exam to successfully pass your exam.Here you will find Free Braindump2go Cisco Practice Sample Exam Test Questions that will help you prepare in passing the 350-080 exam.Braindump2go Guarantees you 100% PASS exam 350-080!

Vendor: Cisco
Exam Code: 350-080
Exam Name: CCIE Data Center Written Exam

350-080 Dumps,350-080 Exam Dumps,350-080 Brainfump,350-080 Questions,350-080 VCE,350-080 PDF,350-080 Actual Test,350-080 Study Guide,350-080 Book,350-080 CCIE Data Center Written Exam,350-080 Test

QUESTION 281
What are two benefits of a FabricPath network? (Choose two.)

A.    Simplicity of configuration
B.    Automatic OSPF routing
C.    Scalability
D.    Dynamic link selection
E.    Spanning tree loop prioritization.

Answer: AC

QUESTION 282
Refer to the exhibit. Which of these technologies is illustrated by the topology in the exhibit?


A.    vPC+
B.    standard vPC
C.    enhanced vPC
D.    express vPC
E.    fabric vPC

Answer: C

QUESTION 283
Refer to the exhibit. The interface remains in a down state after entering the command that is shown in the exhibit. What is the cause of the problem?


A.    The feature interface-vlan command must be configured.
B.    The VDC contains only F1 interfaces.
C.    There are IP address conflicts.
D.    The VDC is “type OTV.”
E.    The command copy run start was not entered.

Answer: B

QUESTION 284
NPV and NPIV are features that are used to overcome resource limitations in which Fibre Channel field?

A.    FCID
B.    Domain ID
C.    WWPN
D.    LUN ID
E.    VSAN

Answer: B

QUESTION 285
What are the three prerequisites for enabling FCoE on a Cisco Nexus 7000? (Choose three.)

A.    M Series module
B.    F Series module
C.    no-drop QoS policy
D.    NPIV feature
E.    FCoE module license
F.    Fabric Extender configured

Answer: BCE

QUESTION 286
How many virtual interfaces do the Cisco UCS 1280, 1240, and 1225 Virtual Interface Cards support?

A.    128
B.    64
C.    256
D.    1024
E.    100

Answer: C

QUESTION 287
When you connect two Cisco devices through 802.1Q trunks, the devices exchange spanning tree BPDUs on each VLAN that is allowed on the trunks. Which two statements are correct about the BPDUs that are sent on the native VLAN of the trunk? (Choose two.)

A.    BPDUs are sent to the reserved IEEE 802.1D spanning tree multicast MAC address (01- 80-C2-00-00-00).
B.    BPDUs are sent to the reserved IEEE 802.1q spanning tree multicast MAC address (01- 80-C2-00-00-00).
C.    BPDUs are sent to the reserved SSTP multicast MAC address (01-00-0c-cc-cc-cd).
D.    BPDUs are tagged with the VLAN number when they are sent.
E.    BPDUs are untagged when they are sent.

Answer: AE

QUESTION 288
Consistency checks and compatibility checks are performed before a vPC is created. During a compatibility check, one vPC peer conveys configuration information to the other vPC peer to verify that vPC member ports can actually form a port channel. Which two statements about virtual port channel graceful consistency checks are true? (Choose two.)

A.    Graceful consistency check is enabled by default.
B.    When graceful consistency check is enabled, only the links on the secondary peer device are suspended.
C.    Graceful consistency check is disabled by default. To enable this feature, use the graceful consistency-check command under the vPC domain configuration mode.
D.    When graceful consistency check is enabled, only the inconsistent VLANs on the secondary peer device are suspended.
E.    Graceful consistency check is disabled by default.

Answer: AB

QUESTION 289
Consistency checks and compatibility checks are performed before a vPC is created. During a compatibility check, one vPC peer conveys configuration information to the other vPC peer to verify that vPC member ports can actually form a port channel. Which option is considered as a Type-2 misconfiguration?

A.    port MTU mismatch
B.    native VLAN mismatch
C.    STP interface settings
D.    VLAN mismatch

Answer: D

QUESTION 290
Which three statements about Cisco FabricPath are correct? (Choose three.)

A.    Only F1 or F2 ports can be used as FabricPath core ports.
B.    Only F1 or F2 ports can be used as edge ports to connect a legacy spanning tree domain (to switch traffic over the FabricPath domain).
C.    A FabricPath VLAN can exist on F1 or F2 ports only.
D.    Only M1 or M2 ports can be used as FabricPath core ports.
E.    Only F2 ports can be used as edge ports to connect a legacy spanning tree domain (to switch traffic over the FabricPath domain).
F.    A FabricPath VLAN can exist on F1 ports only.

Answer: ABC


For those who feel the overwhelming anxiety before their 350-080 exam,Braindump2go Latest updated 350-080 Exam Dumps will help you Pass 100% in a short time preparation! 350-080 Exam Dumps PDF & VCE Full Version Instant Download!

FREE DOWNLOAD: NEW UPDATED 350-080 PDF Dumps & 350-080 VCE Dumps from Braindump2go: http://www.braindump2go.com/350-080.html (394 Q&A)