This page was exported from Online Latest Braindump2go Microsoft Exam Dumps Free Share [ http://www.adobedumps.com ] Export date:Sat Sep 21 0:45:39 2019 / +0000 GMT ___________________________________________________ Title: [March-2018-New]300-165 Exam Dumps VCE 214Q Free Shared by Braindump2go[105-115] --------------------------------------------------- 2018 March New Cisco 300-165 Exam Dumps with PDF and VCE Free Updated Today! Following are some new 300-165 Real Exam Questions:1.|2018 Latest 300-165 Exam Dumps (PDF & VCE) 214Q&As Download:https://www.braindump2go.com/300-165.html2.|2018 Latest 300-165 Exam Questions & Answers Download:https://drive.google.com/drive/folders/0B75b5xYLjSSNRU9xWGk1cFJiaTg?usp=sharingQUESTION 105How does addition of bandwidth between spine and leaf switches in a FabricPath architecture get utilized?A. Links between the same set of switches are automatically added to a port channel.B. Adding additional bandwidth is handled dynamically using the 802.1AX protocol.C. Traffic is load shared automatically across the available paths to the destination.D. FabricPath uses hardware bonding of physical interfaces to form higher-speed links.Answer: CQUESTION 106Which two advantages does FabricPath have over Spanning Tree in implementing a loop-free network topology design? (Choose two.)A. Blocked links can be brought in to service if active links fail.B. Convergence times are faster.C. Multipath forwarding is supported for unicast and multicast Layer 2 and Layer 3 traffic.D. Unknown unicast addresses are flooded in through the originating port.Answer: BCQUESTION 107Which four statements about reserved VLANs in Cisco NX-OS are true? (Choose four.)A. The range of reserved VLANs cannot be changed.B. The number of reserved VLANs is 96.C. A change to the range of reserved VLANs can be performed only in the VDC default.D. A write-erase procedure restores the default reserved VLAN range.E. The number of reserved VLANs is 128.F. A reload is needed for changes to take place.G. The configuration must be saved for changes to take place.Answer: CEFGQUESTION 108Which two RFCs are supported by Cisco NX-OS devices for OSPFv2? (Choose two.)A. RFC 2238B. RFC 1918C. RFC 1583D. RFC 2453E. RFC 2740Answer: ACQUESTION 109Which action limits the maximum number of routes that are allowed in the routing table?A. Use a filter BGP.B. Use only static routes.C. Use the maximum routes command inside address family.D. Use a route map to filter routes.Answer: CQUESTION 110Which three options of encryption are supported in PIM hello messages? (Choose three.)A. cleartextB. DES-SHA1C. DES-CBC3-SHAD. Cisco Type 7E. RC4-SHAF. 3DESAnswer: ADFQUESTION 111Which command is used to associate EID-to-RLOC for a LISP site?A. #feature lispB. #ipv6 lisp itrC. #ip lisp database-mappingD. #ip lisp itr map-resolverAnswer: CQUESTION 112In OTV, how are the VLANs split when a site has two edge devices?A. They are configured manually by user.B. They are split in half among each edge device.C. They are split as odd and even VLAN IDs on each edge device.D. It is not possible to have two edge devices in same site.Answer: CQUESTION 113Which statement about the MPLS feature set is true?A. It is not license dependent.B. It can be installed from any VDC.C. It can be enabled only in the default VDC.D. It must be installed from the default VDC.Answer: DQUESTION 114Refer to the exhibit. What is the maximum IPv6 unicast route memory allocated? A. 4 MBB. 8 MBC. 1024 MBD. 1 GBE. 5 MBAnswer: AQUESTION 115When creating a VDC on a Cisco Nexus 7000 switch, which command in the VDC designates that only 10 port channels can be created in that VDC?A. allocate resource port-channel 10B. limit-resource port-channel minimum 0 maximum 10C. allow-resource port-channel maximum 10D. port-channel maximum 10Answer: B!!!RECOMMEND!!!1.|2018 Latest 300-165 Exam Dumps (PDF & VCE) 214Q&As Download:https://www.braindump2go.com/300-165.html2.|2018 Latest 300-165 Study Guide Video: YouTube Video: YouTube.com/watch?v=DCl4Vh2Wt0k --------------------------------------------------- Images: --------------------------------------------------- --------------------------------------------------- Post date: 2018-03-29 07:42:12 Post date GMT: 2018-03-29 07:42:12 Post modified date: 2018-03-29 07:42:12 Post modified date GMT: 2018-03-29 07:42:12 ____________________________________________________________________________________________ Export of Post and Page as text file has been powered by [ Universal Post Manager ] plugin from www.gconverters.com